ScaleAwayTM - The NEW bio-degradable eco friendly commercial descaler

ScaleAwayTM Descaler
The Most Effective Way To Improve The Heat Transfer Efficiency Of Your Tankless Water Heater

Limescale Management

   Plastic Moulding Industry
   Rubber Industry
   Heat Exchangers & Oil Coolers
   Cooling Tower Services
   Water Boilers & Furnaces
   Water Chillers & Air Conditioners
   Compressors & Vacuum Pumps
   Marine Descaler for Boat Motors
   Electrical Water Geysers
   Tankless Water Heaters

Preventative Maintenance Service
   Servicing of Heat Transfer Equipment
   Monthly Water Treatment Service
   Complete Plant Rehabilitation

Buy ScaleAway Products
   Complete Product Listing
   Descaling Pump Carts
   Chemical Dosing System
   Ion-Exchange Water Softening Units
   Cooling Water Filtration

Types of Water Scale
   Calcium Carbonate Scale
   Calcium Sulphate Scale
   Silica Scale

Tech Zone
   Limescale Build-up
   Fouling of Equipment
   Limescale Removal
   Photo Gallery

Tech Terms
   Descaling Agents
   What is Passivation
   Corrosion Inhibitors

The Company
   Mission & Objectives
   Contact ScaleAway


Descaler Kit Improves Tankless Water Heater Efficiency
ScaleAwayBIO Descaler Kit has been designed to work in conjunction with isolation valves that provide 20mm (3/4") hot and cold service connections. If these valves have not been installed on your tankless water heater, then the heater must be disconnected from the plumbing and drained, and the ScaleAwayBIO System Descaler Kit must be connected directly to the cold and hot water connections.

Descaling Procedure:
1. Disconnect power to water heater.

2. Close hot and cold isolation and service valves and remove service caps.

3. Pour 5 litres of water into the bucket and place under water heater.

4. Connect one hose to pump, and other end of same hose to cold service valve. Place pump inside the bucket.

5. Add contents of 5 litre of ScaleAwayBIO to bucket (Liquid should just cover pump housing). Additional ScaleAwayBIO may be necessary in larger or heavily scaled systems.

6. Connect second hose to hot service valve. Place other end in bucket.

7. Open both hot and cold service valves.

8. Plug pump into grounded electrical wall socket. Never allow pump to run without adequate liquid in bucket or damage to the pump will occur.

9. Allow pump to circulate ScaleAwayBIO solution through heater for 30-45 minutes. Unplug pump.

10. Close cold service valve. Remove hose from cold service valve, and replace service cap.

11. Disconnect the hose from the pump and remove pump from bucket. Discard used ScaleAwayBIO solution*.

12. Flush tankless water heater for 5-10 minutes or until water flows clear by opening the cold isolation valve and allowing water to exit through the hot service valve into a drain (connect two hoses if necessary) or drain into a bucket. If using a bucket, empty periodically.

13. Close hot service valve. Remove hose from service valve and replace service cap; then open hot isolation valve.

14. Connect power to water heater and return appliance to service.

Because ScaleAwayBIO is an eco friendly non-toxic bio-degradable product, it is fast replacing all toxic descalers.

ScaleAwayBIO is described as being a “green descaler” because of its ecological advantages.

Contact us TODAY to to purchase this product!

  • Return to the ScaleAwayBIO Page
  • Return to the Products Page
  • Copyright & copy; 2010-2017 ScaleAway a member of the Industrial Piping Solutions Group. - All rights reserved.